Skip to main content
WY
💧

Well Drilling in Wyoming

Avg. $6,000 - $25,000 · One-time (well lifespan 30-50 years)

2
Cities
$6,000 - $25,000
Avg. Cost

Water well drilling is the process of boring a hole into the earth to access underground aquifers that provide fresh water for drinking, irrigation, and household use. Approximately 43 million Americans rely on private wells as their primary water source. Residential wells typically range from 100 to 500 feet deep depending on the local geology and water table depth, though some areas require wells exceeding 1,000 feet. The drilling method depends on the geological conditions — rotary drilling is most common for deep wells through rock formations, while cable tool (percussion) drilling works well in unconsolidated materials like sand and gravel. After drilling, the well is cased with steel or PVC pipe to prevent contamination from surface water, and a submersible pump is installed at the appropriate depth to bring water to the surface. A pressure tank system in your home maintains consistent water pressure. The complete system includes the well itself, casing, pump, pressure tank, and connection piping. New wells require permits from state or local water authorities, and most states mandate a water quality test before the well can be used. Costs vary enormously by region and depth — from $6,000 in the Southeast to over $30,000 in areas with deep bedrock or difficult drilling conditions.

Wyoming Regulations for Well Drilling

Wyoming regulates onsite wastewater systems through the Wyoming Department of Environmental Quality (WDEQ) Water Quality Division under Wyoming Statutes 35-11 and DEQ Chapter 25 regulations. County planning and zoning offices administer local permits in coordination with state guidelines. All new installations require site evaluation, soil percolation testing, and a permit from the appropriate county. Subdivisions require a wastewater feasibility analysis before approval. Systems in the Yellowstone caldera region and near trout streams face the strictest setback and performance standards in the state. High altitude mountain communities require frost-protected installations with tank burial depths often exceeding 5 feet.

Licensing Requirements

Wyoming requires all septic system installers to hold a valid WDEQ Registered Wastewater Installer credential. Pumpers must register with WDEQ and hold a Septage Hauler permit. Work near state waters requires additional WDEQ Surface Water Quality permits.

Environmental Considerations

Wyoming soils span a wide range from expansive Bentonite-rich clays in the Bighorn Basin to well-draining sandy alluvium along river valleys and shallow rocky soils in mountainous terrain. Bentonite clay soils have extremely low percolation rates and often require engineered mound systems. Frost depths of 4 to 6 feet are common. The state's abundant clear streams and rivers used for fly fishing and livestock watering demand strict setbacks and high-performing systems.

Signs You Need Well Drilling

  • Building a new home without access to municipal water supply
  • Existing well has gone dry or produces insufficient water
  • Water quality has deteriorated beyond what treatment can fix
  • Adding irrigation needs that exceed existing well capacity
  • Existing well is contaminated and cannot be rehabilitated

The Well Drilling Process

  1. 1 Site assessment and hydrogeological survey to identify the best drilling location
  2. 2 Obtain required drilling permits from state or local water authority
  3. 3 Mobilize drilling rig and begin boring through soil and rock layers
  4. 4 Install well casing and screen at the appropriate aquifer depth
  5. 5 Develop the well by pumping to clear drilling debris and maximize flow
  6. 6 Install submersible pump, pressure tank, and connection piping
  7. 7 Conduct water quality testing and obtain certificate of completion

Frequently Asked Questions — Well Drilling in Wyoming

How much does it cost to drill a well?
Well drilling costs $15-$85 per foot depending on geology, plus pump, casing, and completion. Total project costs by region: Southeast $6,000-$12,000 (shallow aquifers), Mid-Atlantic $12,000-$18,000, Midwest $8,000-$12,000, and Western states $20,000-$50,000+ (hard rock, deep aquifers). The biggest cost driver is depth — research nearby well logs before requesting quotes.
How deep does a residential well need to be?
Deep enough to reach a reliable aquifer with adequate yield (3-5 gallons per minute minimum for most homes). Average depths vary dramatically: Florida 40-80 feet, Southeast 100-200 feet, Mid-Atlantic 150-300 feet, and Western mountain areas 300-600 feet. Your county may have well log databases showing depths of nearby wells — this is the best predictor of what your well will require.
How long does it take to drill a well?
The drilling itself takes 1-3 days for most residential wells. However, the full timeline includes permitting (1-4 weeks), driller scheduling (1-4 weeks depending on season), drilling and completion (1-3 days), water quality testing (1-2 weeks for lab results), and plumbing connection (1-2 days). Total timeline from decision to running water is typically 4-10 weeks.
What happens if the driller does not hit water?
Policies vary by driller. Most charge their per-foot rate regardless — you pay for the hole whether it produces water or not. Some offer depth guarantees (drill up to a set depth before declaring dry). A few provide dry hole insurance (adds 10-15% to the quote). In the eastern US, dry holes are uncommon (under 5%). In western hard-rock areas, rates reach 10-15%. Ask about dry hole policy before signing any contract.

Find Well Drilling in Wyoming Cities

Browse 2 cities in Wyoming for well drilling providers.

Casper, WY Pop. 58,892
Cheyenne, WY Pop. 65,132

Other Services in Wyoming

🌿

Drain Field Repair

Restore or replace failed leach fields and drain lines to prevent sewage surfaci…

 🍳

Grease Trap Pumping

Commercial grease trap cleaning and pumping to prevent sewer blockages and maint…

 🔍

Septic Inspection

Comprehensive evaluation of your septic system's condition, required for real es…

 🏗️

Septic System Installation

Complete new septic system design and installation, from perc testing to final i…

 🚽

Septic Tank Pumping

Regular pumping removes accumulated solids from your septic tank, preventing bac…

 🔧

Septic Repair

Diagnose and fix septic system problems including leaks, clogs, baffle failures,…

 ⚙️

Well Pump Repair

Diagnose and repair well pump failures, pressure tank issues, and water flow pro…