Skip to main content

Grease Trap Pumping in Salt Lake City, UT

Salt Lake County County · 0 providers · Avg. $200 - $800

About Grease Trap Pumping in Salt Lake City

Grease trap pumping is a critical maintenance service for restaurants, commercial kitchens, food processing facilities, and any business that discharges fats, oils, and grease (FOG) into its wastewater. Grease traps (also called grease interceptors) capture FOG before it enters the sewer system or septic tank, where it would cause devastating clogs and backups. Local health codes and environmental regulations typically require grease traps to be pumped when the combined grease and solids layer reaches 25% of the trap's capacity — for busy restaurants, this often means pumping every 1 to 3 months. During service, a vacuum truck removes all contents from the trap, including the floating grease layer, settled food solids, and wastewater. The technician will scrape the trap walls, inspect baffles and flow restrictors, and verify the trap is functioning correctly before refilling with clean water. Failure to maintain grease traps can result in sewer backups, foul odors, health department citations, fines of $1,000 or more per violation, and even forced closure. Many jurisdictions require businesses to maintain a pumping log and produce records during health inspections. Professional grease trap services often include manifesting and proper disposal of collected waste at approved facilities.

What Salt Lake City Homeowners Should Know

Local Soil Conditions: Lake Bonneville lakebed deposits — Saltair silty clay loam and Jordan silty clay loam dominate the valley floor; well-sorted lacustrine silts and clays with very slow percolation; Taylorsville loam and Hansel gravelly loam on alluvial fans along the Wasatch Front with moderate percolation

Water Table: 3 to 8 feet in valley floor; 15 to 30 feet on alluvial bench areas

Climate Impact: Semi-arid climate (BSk/Csa) with hot dry summers averaging 97°F and cold winters with moderate snow. Annual precipitation 16 inches. Great Salt Lake effect can produce lake-effect snow on the west side. Inversions trap air pollution in the valley during winter.

Signs You Need Grease Trap Pumping

  • Slow drains in the kitchen, especially floor drains and sink drains
  • Foul odors coming from drains or the grease trap area
  • Grease visible in the trap when the lid is opened
  • Health department notice or citation for trap maintenance
  • Grease backup into sinks or onto the floor
  • It has been more than 90 days since the last pumping

The Grease Trap Pumping Process

  1. 1 Access the grease trap and remove the lid for inspection
  2. 2 Measure the grease and solids accumulation levels
  3. 3 Pump out all contents — grease, solids, and wastewater — with a vacuum truck
  4. 4 Scrape trap walls, baffles, and lid to remove adhered grease
  5. 5 Inspect baffles, flow control devices, and trap integrity
  6. 6 Refill with clean water, document the service, and provide compliance records

No Grease Trap Pumping providers listed yet in Salt Lake City

Are you a grease trap pumping professional in Salt Lake City? List your business for free.

Frequently Asked Questions — Salt Lake City

Can I install a septic system in the Salt Lake Valley?
In most of Salt Lake City proper, municipal sewer service is available and septic systems are not permitted. In unincorporated Salt Lake County and canyon communities, septic is permitted but site conditions vary dramatically. Valley floor properties with Lake Bonneville clay soils typically cannot support conventional systems. Bench and mountain communities with gravelly alluvial soils are much more suitable. A site evaluation is required before any permit is issued.
What makes Salt Lake City's soils challenging for septic systems?
Salt Lake Valley sits on ancient Lake Bonneville lakebed deposits — extremely fine-grained lacustrine silts and clays with very slow percolation rates (often exceeding 120 minutes per inch). Combined with a high seasonal water table driven by Wasatch Mountain snowmelt, these soils make conventional septic installation impractical or impossible in many valley-floor areas. Engineered mound systems, drip irrigation systems, or connection to community sewer are the typical solutions.
Are septic systems allowed in Salt Lake City's protected watersheds?
Big Cottonwood Canyon and Little Cottonwood Canyon are part of Salt Lake City's protected municipal watershed and have the most restrictive standards. New septic systems in these canyons require Salt Lake City's approval in addition to county permitting, and many areas require connection to a community sewer system or engineered vault-and-haul systems. Contact the Salt Lake County Health Department for current watershed regulations before purchasing canyon property.
How does the Great Salt Lake affect septic systems in the area?
The Great Salt Lake influences groundwater levels and soil chemistry in the western Salt Lake Valley. Properties near the lake's historic shoreline may encounter saline soils and high water tables that complicate both system design and the biological treatment process. These conditions are less common in suburban areas but relevant for properties in unincorporated western Salt Lake County.
What are typical septic pumping costs in Salt Lake City?
Septic tank pumping in the Salt Lake City area runs $275 to $450 for a standard residential tank. Prices are competitive due to several active pumping companies serving the Wasatch Front. Canyon properties may incur higher access fees of $50 to $150. Pumping frequency depends on household size — most 3-bedroom homes need pumping every 3 to 5 years.

Other Services in Salt Lake City

🌿Drain Field Repair🔍Septic Inspection🏗️Septic System Installation🚽Septic Tank Pumping🔧Septic Repair💧Well Drilling⚙️Well Pump Repair🔬Well Water Testing💦Well Water Treatment

Nearby Cities

Also serving these areas

Provo, UT